Marley Concrete Plain Roof Tile

As low as

(£0.43 Incl. VAT)
Availability: In stock
- +

Pricing & Availability:

The pricing on this product is applicable to deliveries made to sites within the locality of our branches (which is broadly Surrey, Sussex, London and parts of Kent, Hampshire & Berkshire).

For pricing and availability on these products to sites that are outside of our local area please contact us directly so that we can explore the most cost effective options for you.

We also stock and supply a large range of roofing materials, with thousands more being available to order directly from all the leading manufacturers. If you don't see the roofing products that you need on this site please contact us and we will try to source them for you or offer you an alternative.

We are able to offer prices tailored to your exact requirements & project: Please call us on 01737 763008 or email us for a free quotation.


** Please note that these products can only be supplied in full pallets **



Marley Concrete Plain Roof Tile

The authentic, traditional design of the Marley Eternit Plain tile gives it the looks to match its outstanding versatility.

This range of tiles is especially suitable for details such as dormers, eyebrows and conical roofs as well as vertical cladding, and is available in both smooth face and granular finishes and the choice of 9 attractive colours.


Pallet Quantity

  • Quantity per pallet: 900
  • Supplied in bands of 10


  • Weight of tiling: 73.8kg/m2 (0.72 kN/m2) at 100mm gauge (roof) (approx.) / 58kg/m2 (0.57 kN/m2) at 115mm gauge (vertical)

Minimum Roof Pitch & Headlap

  • Minimum pitch: 35 degrees
  • Maximum pitch: 90 degrees
  • Minimum headlap: 65mm (roof) / 37.5mm (vertical)


  • Covering capacity: 60 tiles/m2 at 100mm gauge (roof) / 53 tiles/m2 at 115mm gauge (vertical)
  • Cover width: 168mm (nominal)


  • Battens required: 10.0 linear m/m2 at 100mm gauge (roof) (net) / 8.7 linear m/m2 at 115mm gauge (vertical)
  • Batten size: 38mm x 25mm for rafters/supports not exceeding 600mm recommended centres (fixed to BS 5534)
  • Tile nails: 38mm x 2.65mm

Tile Size

  • Size of tile: 265mm x 165mm


  • Maximum gauge: 100mm (roof) / 115mm (vertical)


  • Tested for resistance to wind driven rain
  • Meets the requirements of BS 5534 with respect to wind loading


  • Material: Concrete


  • At eaves, use double courses with purpose made Eaves/Top Tiles for the undercourse.
  • At verges and abutments to maintain broken bond, use standard Plain Tiles and Tile-and-a-halves in alternate courses.
  • Adjacent to hips, valleys and angles use Tile-and-a-halves. At side abutments, allow for stepped flashing and soakers.
  • At top courses use double courses with purpose made Eaves/Top Tiles for the top course.
  • For Winchester Cuts use two Tile-and-a-halves per course.
  • Winchester Cut detail must not be used to abut roof pitches below 40 degrees or in exposed locations. In these cases soldier or double soldier courses must be used.
  • Should be fixed to comply with the revised British Standard for Slating and Tiling BS 5534: 2014, NHBC Technical Standards (where applicable) and BS 8000: Part 6: the British Standard Code of practice for workmanship on building sites.