Cromar Block and Paving Seal 5 litre
Cromar Block and Paving Seal 5 litre
Available
Have a Question?
Our team have wealth of knowledge so why not pick their brains? Call us on 01306 770490.
Delivery Cost
Proceed to the Basket Page and use our Delivery Calculator for your order.
FREE Click & Collect
Simply proceed to the checkout and select one of our stores: Dorking (Surrey), Redhill (Surrey), East Grinstead (Sussex) and Esher (Surrey).
Related Products
Description
Cromar Block and Paving Seal 5 litre
Block & Paving Sealer is a ready to use effective protection of block pavers and masonry and provides a durable penetrative sealer to a wide variety of materials including concrete, screeds, brickwork, masonry and fibrous sheet materials.
The use of Block & Paving Sealer helps provide protection to both new and existing concrete and masonry against water and air borne pollutants
Coverage:
- Varies depending on the porosity of the substrate
- Guidleine coverage is 6m/2 per litre
Technical
Technical + -
- VOC Details: EU Limit for this product CAT. 2(h) : 30g/l (2010)
- This product contains max. 0g/l VOC's
Coverage + -
- Coverage will vary depending on the porosity of the substrate
- Guidleine coverage is 6m/2 per litre
Features
- Can be applied to green concrete (after 4 - 6 weeks)
- Non-yellowing
- Dual Sealer and Curing Action
- High Penetration
- Suitable to receive subsequent treatments
- Can be used on horizontal or vertical surfaces
- Vapour permeable allowing the substrate to breath
- Provides increased protection to atmospheric gases including carbon dioxide
- Supplied ready for use.
Fixing
Application:
- Block & Paving Seal is supplied ready for use
- All surfaces must be dry and sound and free from any oil, grease, treatment debris and algae
- New concrete must be left for 4 to 6 weeks prior to treatment
- Do not apply if rain is likely within 3 to 4 hours of application
- Apply to a small test area if in doubt and leave for 24 hours
- Apply by brush or roller, work well into the surface taking care not to brush out jointing sand
- Apply one or two coats dependent on desired effect
- Allow 2 to 3 hours between coats
- Product must be left at least 48 hours to fully cure before the treated area can allow any form of traffic
- Clean equipment with soapy water
- Dilution: Shake or stir container before use